Specialty Antennas

CCI Portal Login

CCI Customer Portal

CCI Register

In the Americas
   
 
 
 
Sales  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Customer Service  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Technical Support  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
 
      Six-Beam Special Events Antenna MBA6-9F-V-H3
                
       
       
         
  PI MBA69FVH3 front iso 20150904  
  • Three foot (0.6 m) tall, single panel design supporting six beams without mount changes
  • Dual +45° and -45° cross-polarization for each beam pair
  • Separate beams support 6 sub-sectors
  • Rugged, weather resistant and highly reliable internal design
  • Enables efficient evolution of wireless networks
  • Increase site capacity through higher order sectorization
  • Avoid carrier-adds and building of new capacity sites
  • Boosts data throughput by lowering interference
  • Patented beam shaping technology maximizes coverage
  • Optimized beam crossover and spacing for maximum throughput

Overview

 

The CCI Six-Beam Special Events Antenna is an LTE ready multi-beam antenna that supports multiple sectors (6) from a single antenna. This Six-Beam Antenna is intended for use at sporting and entertainment venues where social media and the ability to share photos and videos demand high capacity and high data rates. This Six-beam antenna has one row of six dual +45° and -45° cross-polarized beam pairs, each roughly 15 degrees apart that are used to segment large audiences into multiple sectors. The antenna enables maximum spectrum re-use by sectorization, providing as much as nine times increase in network capacity. Our unique beam shaping technology provides fast roll off between beams, minimizing interference between sectors thus increasing the carrier to interference plus noise (CINR) ratio and lowering soft handover losses in LTE networks. Such an approach enhances data transfer rates within LTE network sectors and addresses “hotspots” in mobile wireless operator networks.

The single panel design of the CCI Six-Beam Special Event Antenna offers the opportunity to reduce antenna count and directly replaces multiple narrow beam antennas. The antenna minimizes the need for optimization as each beam is spaced optimally for maximum throughput thus providing significant CAPEX and OPEX cost savings.

CCI antennas are designed and produced to ISO 9001:2008 certification standards for reliability and quality in our state-of-the-art manufacturing facilities.

Applications

 
  • Upgrade of data-throughput or capacity constrained sites
  • Antenna intended for use at sporting and entertainment venues

Electrical

Ports 12 × High Band Ports for 2300-2690 MHz
Frequency Range 2300-2400 MHz 2496-2690 MHz
Gain 22.1 dBi 22.6 dBi
Azimuth Beamwidth (-3dB) 9.2° 8.2°
Azimuth Beam Crossover -10.5 dB -10.5 dB
Elevation Beamwidth (-3dB) 12.3° 10.9°
Electrical Downtilt
Elevation Sidelobes (1st Upper) < -20 dB < -18 dB
Front-to-Back Ratio @180° > 35 dB > 35 dB
Cross-Polar Port-to-Port Isolation > 30 dB > 30 dB
Interbeam Co-Pol Isolation (Adjacent Beams) > 15 dB > 15 dB
Interbeam Co-Pol Isolation (Non-Adjacent Beams) > 12.5 dB > 13.5 dB
Voltage Standing Wave Ratio(VSWR) < 1.5:1 < 1.5:1
Passive Intermodulation (2×20W) ≤ -153 dBc ≤ -153 dBc
Input Power Continuous Wave per Port 200 watts 200 watts
Polarization Dual Pol 45° Dual Pol 45°
Input Impedance 50 ohms 50 ohms
Lightning Protection DC Ground DC Ground

Mechanical

Dimensions (L×W×D) 24.7×38.2×6.4 in (628×970×163 mm)
Survival Wind Speed > 125 mph (> 201 kph)
Front Wind Load 201 lbs (896 N) @ 100 mph (161 kph)
Side Wind Load 36 lbs (158 N) @ 100 mph (161 kph)
Equivalent Flat Plate Area 7.9 ft2 (0.7 m2)
Weight * 50.7 lbs (23.0 kg)
Connector 12 × 7-16 DIN female long neck
Mounting Pole 2 to 5 in (5 to 12 cm) (x2)
Mounting Pole spacing 25.6 in (650 mm)
* Weight excludes mounting
Bottom View  
  PI MBA69FVH3 bottom with labels 20150904
Connector Spacing  
  PI MBA69FVH3 Connectorspacing 20150904

Typical Antenna Patterns

  For detailed information on additional antenna patterns, contact customer support at
  MBA69FVH3 AP 2360 AZ MBA69FVH3 AP 2360 EL4
  2360 MHz Azimuth 2360 MHz Elevation 4° 
  MBA69FVH3 AP 2640 AZ MBA69FVH3 AP 2640 EL4
  2640 MHz Azimuth 2640 MHz Elevation 4° 
 

Software/Firmware

pdficon large OPA-Firmware Upgrade Instructions
 softwareicon Current Firmware

Parts & Accessories

MBA6-9F-V-H3 3' (0.6 m) Special Events Six-Beam Antenna with Fixed Electrical Tilt
MBA6-9F-V-H3-K 3' (0.6 m) Antenna and 2x MBK-03 Mounting Bracket
MBK-03 x 2 Mounting bracket kit (top and bottom) with 0° to 12° mechanical tilt adjustment

Standards & Compliance

Environmental IEC 60068-2-1, IEC 60068-2-2, IEC 60068-2-5, IEC 60068-2-6, IEC-60068-2-11, IEC 60068-2-14, IEC 60068-2-18, IEC 60068-2-27, IEC 60068-2-29, IEC 60068-02-30, IEC 60068-2-52, IEC 60068-2-64, GR-63-CORE 4.3.1, EN 60529, IP 24

Certifications

 Federal Communication Commission (FCC) Part 15 Class B, ISO 9001:2008
 
ISO9001Logo RoHS logo
  Footer
              
     
     
       
 

News

CCILogoType

89 Leuning Street

South Hackensack, NJ 07606

+1 (201) 342-3338

+1 (201) 342-3339 fax