Multi-Port Antennas

CCI Portal Login

CCI Customer Portal

CCI Register

In the Americas
   
 
 
 
Sales  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Customer Service  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
Technical Support  
 
 
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
 
89 Leuning Street  
South Hackensack, NJ 07606  
USA  
 
 
      Twelve Port Multi-Band Antenna TPA65R-BU4A
                
       
       
         
  PI TPA65R BU4AA front iso 2016JUL27 PI TPA65RBU4AA rear iso 2016JUL27  
  • Four foot (1.2 m) multiband, twelve port antenna with a 65° azimuth beamwidth covering 698-798 MHz, 824-896 MHz and 1695-2360 MHz frequencies
  • Total of Eight high band ports, four high wide band ports covering 1695-1780 and 2110-2360 MHz, four additional high band ports covering 1850-1990 MHz. Total of four low band ports, two low band ports for 698-798 MHz and two low band ports for 824-896 MHz in a single enclosure.
  • New enclosure with <12” (305mm) width, narrowest enclosure in the industry
  • Full Spectrum Compliance for WCS and AWS-3 frequencies and upcoming Band 14 Operations
  • LTE Optimized FBR and SPR performance, providing for an efficient use of valuable radio capacity
  • LTE Optimized Boresight and Sector XPD and USL performance, essential for LTE Performance
  • Exceeds minimum PIM performance requirements
  • Equipped with new 4.3-10 connector, which is 40% smaller than traditional 7-16 DIN connector
  • Ordering options for External RET Controllers (Type 1) or Internally Integrated RET Controllers (Type 17)

Overview

 

The CCI 12-Port Multiband Antenna Array is a twelve port antenna with a total of eight high band ports. Four high band ports covering 1695-1780 and 2110-2360 MHz and four additional high band ports covering 1850-1990 MHz. In addition, the antenna includes a total of four low band ports, two ports covering 698-798 MHz and two ports covering 824-896 MHz. The CCI 12-Port provides the capability to deploy Dual 4x4 Multiple-input-Multiple-output (MIMO) in the high band and Dual 2x2 Multiple-input-Multiple-output (MIMO) in the low band. The CCI 12-Port allows for separate tilt control between the low band ports and the high band ports. With the use of four RET controllers, the frequency paired low and high band ports can be tilted independently, enabling maximum flexibility in network deployment.

CCI antennas are designed and produced to ISO 9001:2008 certification standards for reliability and quality in our state-of-the-art manufacturing facilities.

Applications

 
  • Dual 4x4 MIMO for the high band and Dual 2x2 MIMO for the low band ports
  • Ready for Network Standardization on 4.3-10 DIN connectors
  • With CCI’s multiband antennas, wireless providers can connect multiple platforms to a single antenna, reducing tower load, lease expense, deployment time and installation costs

Electrical

       
Ports 2 Low Band Ports for 698-798 MHz 2 Low Band Ports for 824-896 MHz
Frequency Range 698-787 MHz 787-798 MHz 824-896 MHz
Gain1 13.0 dBi 12.6 dBi 13.1 dBi
Gain (Average)2 12.6 dBi 12.3 dBi 12.5 dBi
Azimuth Beamwidth (-3dB) 65° 67° 65°
Elevation Beamwidth (-3dB) 18.4° 16.7° 15.4°
Electrical Downtilt 2° to 16° 2° to 16° 2° to 16°
Elevation Sidelobes (1st Upper) < -19 dB < -16 dB < -19 dB
Front-to-Back Ratio @180° > 32 dB > 33 dB > 35 dB
Front-to-Back Ratio over ± 20° > 30 dB > 30 dB > 34 dB
Cross-Polar Discriminationat Peak > 25 dB > 25 dB > 25 dB
Cross-Polar Discrimination at Sector2 15 dB 11 dB 13 dB
Cross-Polar Port-to-Port Isolation > 25 dB > 25 dB > 25 dB
Voltage Standing Wave Ratio(VSWR) < 1.5:1 < 1.5:1 < 1.5:1
Passive Intermodulation (2×20W) ≤ -150 dBc ≤ -150 dBc ≤ -150 dBc
Input Power Continuous Wave (CW) 500 watts 500 watts 300 watts
Polarization Dual Pol 45° Dual Pol 45° Dual Pol 45°
Input Impedance 50 ohms 50 ohms 50 ohms
Lightning Protection DC Ground DC Ground DC Ground
1Peak gain across sub-bands.
2Electrical specifications follow document "Recommendation on Base Station Antenna Standards" (BASTA) V9.6.
         
Ports 4 High Band Ports for 1850-1990 MHz 4 High Band Ports for 1695-1780 and 2110-2360 MHz
Frequency Range 1850-1990 MHz 1695-1780 MHz 2110-2180 MHz 2305-2360 MHz
Gain1 15.9 dBi 15.0 dBi 16.1 dBi 15.5 dBi
Gain (Average)2 15.2 dBi 14.5 dBi 15.5 dBi 15.1 dBi
Azimuth Beamwidth (-3dB) 60° 62° 57° 62°
Elevation Beamwidth (-3dB) 8.3° 9.4° 7.6° 7.1°
Electrical Downtilt 0° to 9° 0° to 9° 0° to 9° 0° to 9°
Elevation Sidelobes (1st Upper) < -18 dB < -16 dB < -17 dB < -16 dB
Front-to-Back Ratio @180° > 35 dB > 35 dB > 35 dB > 35 dB
Front-to-Back Ratio over ± 20° > 35 dB > 34 dB > 34 dB > 32 dB
Cross-Polar Discrimination at Peak > 18 dB > 23 dB > 22 dB > 25 dB
Cross-Polar Discrimination at Sector2 9 dB 11 dB 7 dB 8 dB
Cross-Polar Port-to-Port Isolation > 25 dB > 25 dB > 25 dB > 25 dB
Voltage Standing Wave Ratio(VSWR) < 1.5:1 < 1.5:1 < 1.5:1 < 1.5:1
Passive Intermodulation (2×20W) ≤ -150 dBc ≤ -150 dBc ≤ -150 dBc ≤ -150 dBc
Input Power Continuous Wave (CW) 300 watts 300 watts 300 watts 300 watts
Polarization Dual Pol 45° Dual Pol 45° Dual Pol 45° Dual Pol 45°
Input Impedance 50 ohms 50 ohms 50 ohms 50 ohms
Lightning Protection DC Ground DC Ground DC Ground DC Ground
1Peak gain across sub-bands.
2Electrical specifications follow document "Recommendation on Base Station Antenna Standards" (BASTA) V9.6.

Mechanical

Dimensions (L×W×D) 48.0×11.8×11.5 in (1220×300×293 mm)
Survival Wind Speed > 150 mph (> 241 kph)
Front Wind Load 128 lbs (569 N) @ 100 mph (161 kph)
Side Wind Load 125 lbs (558 N) @ 100 mph (161 kph)
Equivalent Flat Plate Area 5.0 ft2 (0.5 m2)
Weight*  69.4 lbs (31.5.2 kg)
RET System Weight 6.6 lbs (3.0 kg)
Connector 12 × 4.3-10 Female
Mounting Pole 2 to 5 in (5 to 12 cm)
* Weight excludes mounting and RET
Bottom View TPA65R-BU4AA (Type 1 RET) TPA65R-BU4AB (Type 17 RET)
   PI TPA65RBU4AA bottom  PI TPA65RBU4AB bottom
 
Connector Spacing TPA65R-BU4AA (Type 1 RET) TPA65R-BU4AB (Type 17 RET)
  PI TPA65RBU4AA connectorspacing PI TPA65RBU4AB connectorspacing
Element and RET configuration TPA65R-BU4AA and TPA65R-BU4AB
   PI TPA65RBU6AA RET ELEMENT

Typical Antenna Patterns

  For detailed information on additional antenna patterns, contact customer support at
Az EL TPA65RBU4A AP 734 AZEL9 TPA65RBU4A AP 860 AZEL9
  734 MHz Azimuth with Elevation 9° 860 MHz Azimuth with Elevation 9°
TPA65RLCUUUUH8 1920 LEGEND TPA65RBU4A AP 1920 AZ TPA65RBU4A AP 1920 EL5
  1920 MHz Azimuth 1920 MHz Elevation 5°
TPA65RLCUUUUH8 1920 LEGEND TPA65RBU4A AP 2335 AZ TPA65RBU4A AP 2335 EL5
  2350 MHz Azimuth 2350 MHz Elevation 5°
BSA-RET200   Type 1 remote electrical tilt actuator
BSA-RET400   Type 17 Internal Remote Electrical Tilt System (RET)
OPA-CBK-AG-RRU   Twelve Port antenna to RRU AISG cable kit (Used with BSA-RET200 RET only)
OPA-CBK-RA-AG-RRU   Twelve Port antenna to RRU AISG right angle cable kit (Used with BSA-RET200 RET only)
MBK-02   Mounting bracket kit (top and bottom) with 0° to 10° mechanical tilt adjustment
SCU-AISG2-P   Portable AISG 2.0 Site Control Unit

Software/Firmware

pdficon large HPA-Firmware Upgrade Instructions
 softwareicon Current Firmware

Parts & Accessories

TPA65R-BU4AA-K Four foot (1.2 m) Twelve Port antenna with 4.3-10 female connectors, four factory installed BSA-RET200 RET actuators (Type 1 external) and MBK-02 mounting bracket
TPA65R-BU4AB-K Four foot (1.2 m) Twelve Port antenna with 4.3-10 female connectors, four factory installed BSA-RET400 RET actuators (Type 17 internal) and MBK-02 mounting bracket
MBK-02 Mounting bracket kit (top and bottom) with 0° to 10° mechanical tilt adjustment
BSA-RET200 Type 1 remote electrical tilt actuator
BSA-RET400 Type 17 remote electrical tilt actuator
OPA-CBK-AG-RRU Twelve Port antenna to RRU AISG cable kit (Used with BSA-RET200 RET only)
OPA-CBK-RA-AG-RRU Twelve Port antenna to RRU AISG right angle cable kit (Used with BSA-RET200 RET only)

Standards & Compliance

Safety EN 60950-1, UL 60950-1
Emission EN 55022
Immunity EN 55024
Environmental IEC 60068-2-1, IEC 60068-2-2, IEC 60068-2-5, IEC 60068-2-6, IEC-60068-2-11, IEC 60068-2-14, IEC 60068-2-18, IEC 60068-2-27, IEC 60068-2-29, IEC 60068-02-30, IEC 60068-2-52, IEC 60068-2-64, GR-63-CORE 4.3.1, EN 60529, IP 24

Certifications

Antenna Interface Standards Group (AISG), Federal Communication Commission (FCC) Part 15 Class B, CE, CSA US, ISO 9001:2008
 
ISO9001Logo RoHS logo AISGLogo 3GPPLogo
  Footer
              
     
     
       
 

News

CCILogoType

89 Leuning Street

South Hackensack, NJ 07606

+1 (201) 342-3338

+1 (201) 342-3339 fax