Tower Mounted Amplifiers

CCI Portal Login

CCI Customer Portal

CCI Register

In the Americas
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
89 Leuning Street  
South Hackensack, NJ 07606  
Customer Service  
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
89 Leuning Street  
South Hackensack, NJ 07606  
Technical Support  
+1 (201) 342-3338 phone  
+1 (201)-342-3339 fax  
89 Leuning Street  
South Hackensack, NJ 07606  
      PCS Twin Tower Mounted Amplifier DTMA1819FGXX
  • Small, lightweight, twin unit
  • Dual duplexed
  • High Linearity
  • Lightning protected
  • High reliability
  • Full PCS band




CCI’s Twin TMA contains two TMAs in a single housing.  Each TMA is full band and fully duplexed.  High linearity improves the uplink sensitivity and the receive performance of base stations.  The TMA is powered by a DC PDU and supports CDMA, EDGE/GSM and UMTS BTS equipment.  It provides a convenient package for sites upgraded to dual or quad antenna configurations.  The twin TMA package reduces tower loading, leasing, and installation costs.  Unit count on the tower is cut in half .  An excellent match for two branch receive diversity applications using dual polarization antennas.  The input and output connectors are located inline for ease of installation in space constrained areas such as uni-pole structures and stealth antennas.


Technical Description:

The TMA system consists of a twin outdoor tower mount unit with two antenna inputs.  TMA Gain is to be Customer Specified at time of order over a range from 6 dB to 12 dB.  The tower mount unit is dual duplexed to separate the low-power uplink signal from the high-power downlink signal at the antenna port, amplifies the low-level uplink signal using an ultra-low noise amplifier (LNA), and recombines the two paths at the BTS port.  The tower mount units consist of six band-pass filters, four redundant low-noise amplifiers, bypass failure circuitry, and bias tee’s which are all housed in an IP65 moisture proof enclosure, with IP68 Immersion proof connectors suited to long-life masthead mounting.  The unit provides protection against lightning strikes via a multi-stage surge protection circuit.  DC power and control is provided via the feeder cable from the BTS or a Power Distribution Unit (PDU).
An optional indoor power distribution unit (PDU) is available to power up to three (3) DTMA’s and to provide all the monitoring and alarm functions for the system.  The PDU is housed in a single (1U) 1.75” x 19” rack and contains dual redundant power supplies capable of being “hot swapped” that provide a regulated DC supply voltage on the RF coax for the tower mount amplifiers.


RF Parameters Ports Frequency(MHz) Specification
Return Loss ANT 1850-1910 18 dB min. (15 dB bypass mode)
1930-1990 18 dB min.
BTS 1850-1910 18 dB min. (15 dB bypass mode)
1930-1990 18 dB min.
Gain ANT - BTS 1850-1910 6 to 12 dB nominal (±1.0 dB) (Customer specified)
Insertion Loss ANT - BTS (RX Bypass mode) 1850-1910 1.6 dB @ 25°C, 1.8 dB @ 65°C; 2.3 dB @ 25°C, 2.5 dB @ 65°C @ 1910 MHz (band edge) (± 1.0 dB)
ANT - BTS (TX) 1930-1990 0.4 dB typ. (±0.2 dB)
Noise Figure ANT - BTS 1850-1910 1.4 dB @ 25°C, 1.6 dB @ 65°C; 1.7 dB max @ 25°C, 1.9 dB @ 65°C @ 1910 MHz (band edge)
Input Third Order Intercept Point ANT - BTS 1850-1910 +12 dBm min. at max. gain
General Characteristics  
Impedance 50 ohms
Continuous Average Power 200 W max.
Peak Envelope Power 2 kW max.
Intermodulation Performance(all ports) <-110 dBm (-153 dBc) typical (2 × +43 dBm tones) all bands
Operating Voltage +10V to +15V DC provided via coax
Operating Current  120 mA


Operating Temperature   -40˚C to +65˚C
Enclosure IP65 (Unit Body), IP68 (Connector)
MTBF >500,000 hours
Lightning Protection 8/20us, ±2KA max, 10 strikes each per IEC61000-4-5


Connectors   4 × 7-16 DIN female
Dimensions (w/o connectors or brackets)(H×W×D) 10.6 × 7.9 × 2.9 in. (269 × 200 × 74 mm)
Dimensions (with brackets)(H×W×D) 14.3 ×8.3 × 3.2 in. (363 × 211 × 81 mm)
Weight 13.3 lbs (6.0 kg)-with bracket; 12.6 lbs (5.7 kg)-without bracket
Mounting Pole/Wall mounting bracket


   DTMA1819FGXX Outline
  DTMA1819FGXX Outline Drawing


Block Diagram

  DTMA1819FGXX Block Diagram


PDU-1819-3DT Power Distribution and Alarm Unit
BT-0821-DMDF-AG-O DIN-Male RF Port, DIN-Female RF+DC+AISG Port
BT-0821-DFDM-AG-O DIN-Female RF Port, DIN-Male RF+DC+AISG Port
BT-0821-DFDF-AG-O DIN-Female RF Port, DIN-Female RF+DC+AISG Port

Parts & Accessories

DTMA1819FGXX 1900 PCS Full band Fixed Gain Twin TMA

Gain XX
6 dB 06
7 dB 07
8 dB 08
9 dB 09
10 dB 10
11 dB 10
12 dB 12
Example:  DTMA1819FG12 = 12 dB nominal gain


Federal Communication Commission (FCC) Part 15 Class B, CE, CSA US


89 Leuning Street

South Hackensack, NJ 07606

+1 (201) 342-3338

+1 (201) 342-3339 fax